RM Application #1 RM Application #2 RM Application #3 RM Application #4 To make selection of the components easier, the Jergens/OK-Vise team has selected some basic sets to enable an easy start with the Multi-Rail system. In the pictures below you can see some solutions done with each set. █ For three-directional machining █ One or two workpieces can be machined at the same time █ For three-directional machining █ Four workpieces can be machined at the same time █ Also suitable for holding long workpieces █ To hold large workpieces Code Name Pcs RM-300 Multi-Rail Base 1 RMS-S Stop Module Smooth 2 RMC-DS Clamp Module D Smooth 1 Code Name Pcs RM-300 Multi-Rail Base 1 RMS-S Stop Module Smooth 3 RMC-BS Clamp Module B Smooth 2 Code Name Pcs RM-300 Multi-Rail Base 2 RMS-S Stop Module Smooth 6 RMC-BS Clamp Module B Smooth 4 Code Name Pcs RM-100 Multi-Rail Base 2 RM-200 Multi-Rail Base 2 RMC-DS Clamp Module D Smooth 2 RMS-S Stop Module Smooth 4 LOW PROFILE CLAMPING Jergens, Inc. | 15700 S. Waterloo Road | Cleveland, Ohio 44110-3898 USA 334 LOW PROFILE CLAMPING workholding solutions
RkJQdWJsaXNoZXIy NzI2NjY=