Floating Mode Centralizing Mode Machine Vise Mode Universal Mode This is the most fascinating operating mode of the Combo-Rail. Here the fixture adjusts to the place of the workpiece.This is often needed while clamping inaccurate workpieces like castings, forgings or flame cut work pieces.Therefore floating mode installation normally needs positioning with some other means, like two Multi-Rail units, positioning pins, positioning by a robot etc. The jaws move synchronously. The center line of a casting or similar workpiece remains in the same place even if the outer dimensions of the workpiece changes. Centralizingmode In this mode the other jaw is fixed to the base Compared to traditional Vises, in this method the ergonomics are radically improved in vertical machining centres CRH-K250 is a Combo-Rail unit that can be set in all three modes as mentioned before, operating modes by changing the jaw or wedge components (all included). All workpieces from 0 to 120 mm size can be clamped. The base height is 50 mm and total lenght is 250 mm. LOW PROFILE CLAMPING Phone: 877-426-2504 | Fax: +1 216-481-6193 | E-mail: info@jergensinc.com | www.jergensinc.com 341 LOW PROFILE CLAMPING workholding solutions
RkJQdWJsaXNoZXIy NzI2NjY=