Back Mount Bushing Ball Lock® Shank Fixture Plate Liner Bushing Ball Lock® Shank Liner Bushing Subplate Drilled Hole Slip Fit Hole Press Fit Hole Socket Head Cap Screws (3) Face Mount Bushing Fixture Plate Counter-Bored Hole Machine Table or Subplate is no advantage to having more than two locating points. If more than two anged shanks are required to provide additional hold- down force, omit liner bushings in the additional holes in the xture plate and allow 0.030"(0.76mm) over the nominal size. The additional clearance will insure that these holes have no in uence on the locating holes. How accurate should positioning be? The center distance of the receiver bushings in the machine table, tombstone, or subplate should be as accurate as possible ±0.0002"(±0.005mm) recommended. Accurate location will assure interchangeability of numerous xture plates. For accurate repeatability within ±0.0005"(±0.013mm) of true position, both liner bushings in the xture plate should be primary liners and the center distance tolerance should be ±0.0002"(±0.005mm). For a slightly looser t, repeatability within ±0.0015"(±0.04mm) of true position, use one primary and one secondary liner with a center distance tolerance of ±0.001" (±0.03mm). Q. How many shanks are required to locate and lock each fixture? A. Only two shanks, passing through bushings in the xture plates, are required for location. However, additional shanks passing through clearance holes in the xture plate will provide additional holding force distributed across the plate. Q. Is there a preferable location for the liner bushing? A. System repeatability is improved if the liners are located at opposite corners of a rectangular xture plate. For consistency, we recommend locating the liner bushings at top left and bottom right. Q. What are the advantages of using the Ball Lock® System over the conventional method of dowel pins and cap screws? A. Both locating and locking are accomplished in the same motion. Ball Lock® shanks require only 2.5 turns to lock a 1/2–13 (M12) screw with ¾"(18mm) of thread engagement require 10 turns to lock. On CNC machines, the repeatability of xture locations makes indicating of the xture unnecessary. Q. How do I recess the fixtureplate for a clear surface? A. Counterbore the xture plate to a diameter large enough to allow easy removal of the shank. Note: The thickness of the plate section under the head of the shank is critical and must conform to mounting instructions . Q. What if my plate is thinner than the recommended thickness? A. By adjusting the depth of the counterbore for the receiver bushing in the subplate, you can still use the Ball Lock® System. If there are any questions on this type of application, please call 1-877-426-2504. Q. Can I use the shanks in a heated environment? A. The shank is made of alloy steel, heat treated to 40-45 Rc and should with stand temperatures up to 400°F.(200°C). Note: Thermal expansion of xture plates may affect the center distance tolerance and repeatability. Mounting Method With Back Mount Bushing Mounting Method With Face Mount Bushing QUICK CHANGE FIXTURING - ZERO POINT MOUNTING SYSTEM Phone: 877-426-2504 | Fax: +1 216-481-6193 | E-mail: info@jergensinc.com | www.jergensinc.com W7-P1 QUICK CHANGE FIXTURING - BALL LOCK® MOUNTING SYSTEM 7 workholding solutions BALL LOCK® MOUNTING SYSTEM
RkJQdWJsaXNoZXIy NzI2NjY=